Thicker side
toward the
top for top
installation
Thicker
side toward
the bottom
for bottom
installation
1/4 - 20 x 1/2”
Phillips Round
Head Screws
(4)
Cast Louvre Kit
Installation Instructions
Model: EWF36CLK
Basic Universal
(4)
Hinge Cover (2)
CAR153
Please read these instructions before beginning the
Fig. 1 Carton contents.
installation.
General Information
Rear View
Install the louvre kit after all other fireplace installation
work has been completed, thoroughly checked and
tested for proper operation and installation require-
ments.
Check Contents of Shipping Carton
Compare contents shown in Figure 1 with actual parts
received. If any parts are missing or damaged, contact
your local dealer before starting installation.
Metal Flanges
Damper Tab
(Always point down)
Basic Universal
Louvre Kit Parts:
Basic universal (4)
Hinge Cover (2)
1/4 - 20 x 1/2” phillips round head screw (4)
Instruction sheet
20006024
20005994
Side View
Upper Panel Orientation
Tools required: phillips screwdriver, needlenose pliers
Lower Panel Orientation
KT400
Install Basic Universal
Fig. 2 Place basic universal, making sure the damper tabs
engage plate steel metal flanges of fireplace.
1. Insert each basic universal into openings in fire-
place. Be sure the damper tabs have engaged plate
sheet steel flanges in openings. NOTE: The damper
tabs always point down. (Fig. 2)
2. Before inserting upper right panel, push the damper
handle in flush with face. Once the panel is in place,
use needlenose pliers to pull damper handle out
through lattice in panel.
Hinge
3. Adjust the panels for a symmetric appearance.
Hinge Cover
Screws
Install Hinge Covers
1. Align hinge cover on outside of hinge with holes
located in the hinge. (Fig. 3)
2. Attach hinge cover using screws provided.
Hinge cover
will cover this
area.
KT401
Fig. 3 Install hinge cover.
MHSC
149 Cleveland Drive • Paris, Kentucky 40361
20006092 8/08 Rev. 4
|